SuperStock offers millions of photos, videos, and stock assets to creatives around the world. This image of by Ingram Publishing is available for licensing today.

Visually Similar More from Model Cannons and Clocks story

RM
6145-45790885
Model of the Upper Carriage or a 1-pounder Gun. Model of a top suit for a canon of 1 pounds, to be used on the carriage of a sloop. The rectangular body has been rounded to the short sides and has eye bolts at the four corners. The cheeks have been replaced by two metal supports that are connected by a bolt; The tappers are closed by pens. The vertebral bolt has been applied between the supports, an elevation screw is applied. Scale 1: 2 (according to Archives).
RM
6145-59495099
Model of a 24-Pounder Gun on a Carriage and Slide, anonymous, anonymous, 1797 - 1800 demonstration model Model of a cannon of 24 pounds on coastal deput. The 57 cm long run has a caliber of 33 mm. The inscriptions are engraved on the barrel, along with crossed anchors and palm branches. The role horse consists of two Parellelle cheeks with four staircases and an ellipse -shaped crop at the bottom, which are connected by the calf and the sole plate. The front ash is attached to the cheeks with brackets. The wooden front wheels consist of two discs. At the rear the model does not have a normal axle with wheels: the cheeks do have a recess for an axle with levers and a ridge under the sole plate, to lift the roller horse on the back. The affit is on a sledge consisting of a framework with a pivot bolt in front, and a jack in the middle for baking. France wood (plant material). brass (alloy). bronze (metal)
RM
6145-59494871
Model of A Disengaging Gear for Paddle Wheels, Royal Factory P. van Vlissingen & Dudok van Heel, 1842 demonstration model Model of the disconnection of the crankshaft of a scoop wheel, on a ground board. The pen of the stool falls into a hollow bus in the eye of the stool of the Rader axis, which can be screwed loose and removed and therefore disconnects the ashes. With each battle, the pen from the stool then moves freely through the slot of the wheel stool, which has been opened at the site of the bus. Scale 1:10 (derived). model maker: Amsterdamafter design by: United Kingdom wood (plant material). brass (alloy)
RM
6145-58856489
Pendula van Messing, firm under the Sint-Maarten, c. 1905 Pendulum from brass, square with a roof, on four legs that rest on a square plate. Decorated dial. Round sling plate and in the middle of the base plate decorated with blue stone. Furniture Worker: Zaltbommeldesigner: Netherlands designer: Netherlands brass (alloy) Pendulum from brass, square with a roof, on four legs that rest on a square plate. Decorated dial. Round sling plate and in the middle of the base plate decorated with blue stone. Furniture Worker: Zaltbommeldesigner: Netherlands designer: Netherlands brass (alloy)
RM
1525-22483358
chinese antique compass . chinese sun dial with compass
RM
6145-59494135
Model of a Support in a Dry Dock, anonymous, 1849 demonstration model Schematic model of a part of a dry dock, with part of a ship's wall on blocks supported by a composite goat: with a heath and pal the goat can be put in different positions, adapting to the slope and height of the ship's surface. United States of America wood (plant material). brass (alloy)
RM
6145-45802730
Model of A Wood Kiln. Model of a wood stove or steam box with double bottom for bending shelves, on a base plank. It is a long, curved coffin in which two levels are applied. One of the long sides, in which small doors are applied, is globally bent. Iron leggers are applied to the floors of both the lower and upper compartment. The box has a sliding door on a short side with a hoist for the upper compartment, the door for the lower compartment is missing. On the other hand there is a boiler with pipes to the two compartments; Under the boiler, under ground level, is an oven door.
RM
6145-59494976
Model of Steering Gear, anonymous, 1820 - 1858 demonstration model Model of a steering device with needle on a ground board. The model shows a square Roerkop to which a toothed quadrant is attached; With a gear on an axle, the movement of the steering wheel is transferred to the quadrant. The steering wheel consists of four spokes. Netherlands (possibly) wood (plant material). brass (alloy)
RM
6145-52772751
Lloyd roll film folap camera by Hüttig AG, materials include wood, metal, and leather, measuring 9 x 12 cm, produced after 1900.
RM
6145-45629239
Model or a hydraulic press. Model of a simple hydraulic press on a wooden base plank. On the one hand, a hand-held pump is equipped with a pump arm, regulator, overflow and safety valve. The pump arm can be set in two positions. The regulator is a screw valve. The safety valve is adjusted by weight. From the pump a tube for the liquid runs to the bottom of the press, where an oval perplator is pressed upwards.
RM
6145-52772654
A 9 x 12 cm wooden magazine box camera from the second half of the 19th century, produced anonymously, showing design, wood body, and photographic function.
RM
6145-52772469
Travel camera measuring 18 x 24 cm by August Moll (father), constructed of wood, produced between 1870 and 1885.
RM
6145-59494423
Model of A Skylight, Rijkswerf Vlissingen, 1857 demonstration model Model of a cuckoo on a standard. The upper part is square with flat roof and three windows on each side. It can be left up and down by striking the edges of the hatch head, which turn with hinges; The cuckoo stands on these edges with its base when it is established, and hangs on it with his eaves when it is lowered. Flushing wood (plant material). brass (alloy)
RM
6145-52772647
Wooden travel camera by Rudolf Lechner, measuring 21 x 26 cm, used for photography after 1877.
RM
6145-45803570
Model or steering gear. Model of a steering gear with wheeldram on a base board. The model shows a square stirrer to which a toothed quadrant is attached; With a gear on a shaft, the movement of the steering wheel is transferred to the quadrant. The steering wheel consists of four spokes.
RM
6145-52772750
Travel camera of unknown producer, wooden construction, measuring 13 x 18 cm, manufactured around 1900.
RM
6188-56030429
Old Time Clock for time recording Old Time clock for the recording of working hours. Copyright: xZoonar.com/JFsxPicxFactory xThielemannx 10918405
RM
6145-30193931
Miniature Model of a Wall Gun Made 1670-1700 Germany. Brass, wood, ivory, and ebony .
RM
4409-17461246
Pewter Inkwell. Dated: c. 1936. Dimensions: overall: 22.9 x 30.4 cm (9 x 11 15/16 in.) Original IAD Object: 2 1/2" high; 6 3/4" long; 4 1/2" wide. Medium: graphite and gouache on paper. Museum: National Gallery of Art, Washington DC. Author: Salvatore Borrazzo.
RM
6145-46802801
Compass in OriginalBox. Maker: Andrew Newell, American, 1740-1798 Engraver: Nathaniel Hurd, American, 1730-1777
RM
1815R-156294
Aluminium case
$40.00
Single Image Download High-Res or Vector
Get with Subscription
Looking for a license?
Click here, and we'll help you find it! Questions? Just ask!
DETAILS
Image Number: 1525R-64092Royalty FreeCredit Line:Ingram Publishing/SuperStockCollection:Ingram PublishingStory:Model Cannons and ClocksModel Release:NoProperty Release:NoResolution:3413×5120
02A108CY
background|
blue|
Cabin|
color|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|